Installation Discovery EO, MOH Pa_ No. 65433 Rev.
All specifications are subject to change without notice. Dacor ®assumes © 2007 Dacor, all rights reserved. no liability for changes to specifications.
Before You Begin .............................................................. Important Safety Instructions .......................................... Important Information About Safety Instructions .............. Safety Symbols and Labels ............................................. General Safety Precautions ............................................. Customer Service Information ......................................... If You Need Help ..............................................................
General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING , Read the accompanying use and care manUal , Keep PaCkaging mater als away from children, Plastic sheets and bagS can Cause suffocationl ; , sure this applianCe iS Properly nStalled: D0not use the do0r handle(s)t0 lift or move the Oven :i' ' To prevent injury due to the unit tipping forward.
if You Need Help... Model identification If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive Service line. Whenever you call, have the model and serial number of the appliance ready. The model and serial number are printed on the product data plate. Dacor Distinctive Service (repairs under warranty only) Phone: (877) 337-3226 (U.S.A.
Product Dimensions All tolerances: +1/16 (+1.6 mm), unless otherwise stated. Model Number A B C D E F G H EO127 25 3/8" (64.4 cm) 27" MOH127 (68.6 cm) MOV127 27 15/16" 27 3/8" EO130 (71.0 cm) (69.5 cm) 28 3/8" (72.1 cm) 30" MOH130 (76.2 cm) MOV130 EO227 23 3/8" 2 5/16" 7 3/8" 6 3/8" (59.4 cm) (5.9 cm) (18.7 cm) (16.2 cm) 25 3/8" (64.4 cm) 27" MOH227 (68.6 cm) MOV227 EO230 51 1/16" 50 ½" (129.7 cm) (128.3 cm) 28 3/8" (72.1 cm) 30" MOH230 (76.
Top of chassis H 1 (3.2 cm) G B Control panel front 66" (167.6 cm) Flexible conduit A Chassis notch side view chassis Single Wall Oven Dimensions Top of chassis \ 1 1/4"_ (3.2 cm) Utility cutout Control panel front 66" (167.
Selecting the Location Model Number Carefully check the location where the oven is to be installed. The oven should be placed for convenient access, but away from drafts that may be caused by doors, windows, and heating, ventilation and air conditioning outlets. * B C 25 ½" (64.8 cm) (68.6 cm) EO127 MOH127 Make certain that electrical power can be provided in the selected location. Be certain that proper clearance is provided for the oven door when it is in the open position.
NOTES: D Recommended electrical location Recommended electrical location * Cutout tolerances: +1/16 (1.6 ram), -0, unless otherwise stated. * 24" minimum cutout depth. * 3/4" support platform must be flush with front of cutout. See page 8. \ • • i • • i t 1" (2.5 cm) min. to bottom of door 4" (10.2 cm) min._._._ between cutouts A Duel Single Wall Oven Cutout A - 3/4" (1.9 cm) support platform • • - 3/4" (1.9 cm) support platform i 1 ¾" (4.5 cm) min.
Cabinet Cutout (Continued) Support Platform [_ WARNING The t0p sUrface 0fthe support platform must be !nstalle_ flush with the cutout in the front of the cabinet or wall and any trim Failure tO install the platform prOperly may Cause the exhaUst vent to defo[m and/or become obstructed: An obstructed exhaust area may cause the oven to malfunction. See below. Provide a platform within the cabinet to support the oven. A properly supported piece of 3/4" (1.9 cm) thick plywood is recommended.
Electrical Specifications [_ - iMPORTANT Preheat times and cavity temperature recovery times will be increased slightly if operating on less than a 240 Vac circuit. • This appliance is provided with electrical connection leads in a flexible metal conduit. These leads may be a smaller gage than the standard household wiring of the dedicated supply circuit, but they are suitable for connection to these circuits under the jurisdiction of the National Electric Code, and/or the local inspection authority.
r-, ledr;ca ,, I, , , ,, ,,Insfallaf;on WARNING - Wire the oven only in compliance with local ordinances. • If the electrical service provided does not meet the product specifications, do not proceed with the installation. Call a licensed electrician to install the required wiring. 1 Before proceeding, turn off power to the circuit to which the oven will be connected at the circuit breaker or fuse box. 2. Position the oven directly in front of the cabinet cutout. 3.
Connecting to a Three (3) Wire Electrical System-Where Local Codes Permit [_ Connecting to a Three (3) Wire Electrical System with External Ground - Where Local Codes Permit WARNING [_ Do not connect the green appliance Conduit wire to the unless Jocal building codes permit. J 1. Separate the wires coming out of the appliance conduit. 2. Connect the green and white wires from the appliance conduit to the white (neutral) supply wire in the junction box. 3.
Connecting to a Three (3) Wire Electrical System with External Ground - Where Local Codes Permit (Continued) Cable from circuit Separate No. 10 min. copper grounding wire breaker panel or fuse box Junction box (4 places) / WHITE WHITE E_/ BLACK BLACK _ L i onduit to wall oven Three (3) Wire Connection Final Installation WARNING - A minimum of two people are required to safely install this appliance. - Do not attempt to disengage the hinge catches with the door removed from the oven.
3. Raisethedoorso thatit is ata 15° anglefromthefront of theoven.Holdthedoorwithonehandoneachside. Liftthedoorupandout. , , Support the oven at all times until it is secured into the cabinet. Be certain to take all necessary safety precautions. Resting the oven on the cabinet support platform, slide the oven into the recessed area until the rear edge of the oven trim post is flush with the cabinet face and the oven is centered within the cutout.
Install Exhaust Deflector L CAUTION 1. i , I Instal the exhaust deflect0r before i!Staling the 0 ven l d°°r(s) , 1 Attach the exhaust deflector to the front of the oven. It attaches to the oven just below the oven chamber in the door jam. On a double oven, the exhaust deflector is mounted below the bottom oven chamber. 1. Line up the mounting holes on the exhaust deflector with the screw holes on the front of the oven. 2. Secure it using the three (3) screws provided. , 5.
Lowerlipof hingereceptacle Notchon bottom of hinge Door Installation Installation Checklist WARNING To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor oven cannot be overemphasized, [] Oven is wired to all applicable codes and Dacor specifications. See pages 9 and 10.
16 da=_r
The Life of the Kitchen? Dacor = 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 = Phone: (800) 793-0093 = Fax: (626)403-3130 Family Owned American Made = www.Dacor.
