Installation Instructions

Table Of Contents

Install support platform in cabinet

Provide a platform (100 lb. load capacity) within the cabinet to support the unit. The

platform must be level, straight, and flush with the crossbrace at the front of the cutout.

(See the graphic.) The unit cannot be leveled after installation. 3/4” (1.9 cm) thick

plywood is recommended.

NOTE

If the unit is not level , the drawer may slide open on its own or may not seal tightly,

compromising performance.

Securing the warming drawer to the cabinet

Plug in the unit.

(Taking care not to kink/bunch the power

cord) Insert the chassis in the cutout until

the back of the faceplate stops at the

cleats.

Keeping the chassis centered side to side,

attach inner cabinet side screws starting

with mounting hole #1 through mounting

Hole #7. (See the graphic below.)

Insert the drawer in the chassis.

10 English