Installation Guide

English 23
Installation Instructions
Installing the Rangetop, cont.
SimmerSear Burner Assembly
Keyed
hole
Locating
tab
Burner
base
Ridge on
bottom of
burner cap
B
urner
head
1.
Place the burner heads as shown.
Th
e locater tab
on the head goes in th
e
keyed h
ole as sh
own.
Put the burner caps on th
e burner rings. The
ridge around the bottom edge of the cap fits
around the top of the ring.
3.
Put the burner rings on the heads as shown.
Match th
e tabs on th
e bottom of th
e ring to th
e
slots on the head. Wiggle each
ring to ensure it is
properly seated.
2.
Burner
ring
Tab
slots
Verifying Burner Function
After the cooktop is fully installed and plugged in, make sure all burners work properly.
LO
MED
OFF
HI
1.
2.
Push-turn a burner knob to the flame symbol. (A
“clicking” sound means the electronic ignition
system is functional. The burner ignites about 4
seconds later, after air is purged from the line.)
After ignition, turn the knob to a setting.(The
“clicking” stops; flame height lowers as you turn
the knob counterclockwise.)
3. Perform this procedure
for each burner.
Flame
symbol
Burner
location