cacor a rr renee Installation Instructions Distinctive Series Cooktop Models: DRT304S, DRT366S THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI 221.1 STANDARD FOR HOUSEHOLD GAS APPLIANCES. Part No. 106522 Rev.
of Contents Important Safety INStruCtiONS .........cccceeeeeseseseseeereerereeees Important Information About Safety Instructions.............. General Safety Precautions ...............cccccccccccceeeeeeeeeeenenenes Installation Requirements ..........ccccccecececeeeeeeeeeeeseseneeeeeeeees Electrical Requirements 0.0.0... cccccccccesessssssssesseeeeeeeeees Gas Supply Requirements ...............ccccceceeecceeeeeeeeeeeeenenenes Product DIMENSIONS ..........
Important Safety Instructions Important Information About DANGER Safety Instructions IMPORTANT: * « The Important Safety Instructions and warnings in this manual are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. * Always contact the Dacor Customer Service Team about problems and conditions that you don’t understand. See Customer Service Information. Do not use or.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING Read the accompanying use and:care manual completely before operating this. appliance. Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. If-you receive a damaged product, immediately.contact your dealer or builder.
Installation Requirements Gas Supply Requirements WARNING *. Observe all governing codes and ordinances during planning and installation. Contact your-local building department for further information. *« Check your local building codes for the proper method of installation. In the absence of local codes, this appliance should be installed in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA 54.
Installation Requirements Cabinet and Countertop Layout * To reduce the risk of personal injury and to reduce accumulated smoke in the room, Dacor strongly recommends installing a range hood. A hood should project forward a minimum of five (5) inches beyond the face of the cabinets. * The installation must allow access to the underside of the cooktop for service and inspection purposes, including the ability to turn off the cooktop gas supply valve and electrical outlet.
Installation Requirements Cabinet/C utout Dimensions Cabinet tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted. 4 1/2” (38 mm) 10” (254 mm) to combustible side typical countertop thickness wall Min. both sides > 1/2” (13 mm) overhang, both sides r e H+— 7 3/4” (197 mm) @;e Cooktop platform 1” (25 mm) Min.
Installation Requirements Cabinet/Countertop Dimensions (cont.} Cutout tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted. Gas and electrical connections at right rear section of chassis Gas connection and power cord may be routed through bottom or back of chassis Increase countertop and overhang additional 2 1/2” (64 mm) Min.
Installation Instructions Cooktop Installation Unpack the Cooktop WARNING » WARNING If the gas.and electric service provided does not meet the product specifications, do. not: proceed with the installation. Call the dealer, the gas supplier ora licensed electrician. *..--To prevent-damage to the gas pressure regulator, install it.only after.the .cooktop.is mounted in its permanent-position. «The cooktop is heavy. A minimum_of two people are required to safely install it.
Installation Instructions Knob Installation Control 1. Attach the SimmerSear burner knobs as shown below. The SimmerSear knobs have a wider space between the large flame icon and the simmer icon than the standard burner knobs. Align the “D-shaped” opening on the back of each knob with the end of the valve shaft. Carefully push each Knob on until it stops. 2. Attach the remaining knobs which operate the standard burners [By.
Installation Instructions Burner Component Installation WARNING ».-Never attempt to operate the cooktop with any of the. burner parts removed. «Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory. Remove the burner parts and grates from their shipping packages. SimmerSear Burner Assembly Standard Burner Assembly 1. Install the SimmerSear burner ring(s) on top of the SimmerSear burner base(s).
Installation Instructions Verifying Proper Operation NOTE: If the cooktop does not operate properly, follow these troubleshooting steps: WARNING «Make sure that power-to the electrical outletis turned off atthe circuit breaker or.fuse box and that the gas is turned off at the gas supply valve before. proceeding. * The cooktop must be properly grounded at-all times when electrical power is applied. Prior to operating the cooktop, read the accompanying and care manual carefully. use 1.
Y) Ss = fe ep) A C ep) Cc = WIRING DIAGRAM DRT304 3 Tf FL INDICATOR LIGHT 1 FL Single Point W C ° Spark Module Single Point RL RL INDICATOR LIGHT VERIFY PROPER OPERATION AFTER SERVICING iviroe lanrror 0 Spark Module | _@™ t BRiror 8 (TOR B GN RR INDICATOR LIGHT W @ 120V, 60Hz, 0.25A POWER SUPPLY RR B wN\U/B Spark Module Single Point FR INDICATOR LIGHT ° W tot GC FR Single Point 3 " W Spark Module Os eR RL O 8 FR $3 FL O & os 11 dacor
Y) Ss = ce ep) 5 C ep) Cc = g ; g : ; g Teo uy é J MN sO " 6 O od v8 ” oY we = sO Yd ONES J m I a @ M =] j AlddnS Y4MOd YWSC0 ZHO9 ANCL Sino leds ud OLN soln YOLYOION! Julog a[Buig a WUIOg B|DUIS ainpoyy Mewed YY “ON 0 0 § e gq M #—~] To e ; __alnpow weds o4 JulOg afbulg YOLIND! D4 LHONYOLYOION! 34 JUl0g 9jBulg ainpoyy INPOW led yeas ou YOLIND! 08 MN LHON BOLVOION! 38 7] ra M ; _—ainpow weds 1 JUlog ajbulg YOLINDI Td LHOD YOLVOION] Ta J
cdacor The Life of the Kitchen® Dacor e 600 Anton Bivd. Suite 1000 Costa Mesa, CA 92626 « Phone: (800) 793-0093 American Made* Family Owned e Fax: (626) 403-3130 « www.Dacor.
