Install Guide

Table Of Contents

English40

Operations

Control panel

01 Display Displays the menu, settings, and other information.

02 Buttons

• When the display is off, tap any button to wake up the display.

• Tap

or to navigate left and right.

• Tap to conrm your selection.

• Tap and hold to enter the AP mode. (For more information,

see the “SmartThings > Getting started” section on page 46.)

NOTE

• The control panel is designed to stay off when the refrigerator is not in use. It only

becomes active and lights up when you open the door or tap the buttons.

• If the door is left open for 5 minutes, the internal light will blink for 5 minutes and

turn off. It is to alert deaf and hard of hearing users that a door is open. Note that this

function is normal.

• When you change the temperature on the panel, the panel displays the actual

temperature inside the refrigerator until the temperature matches the temperature you

set. Then, the panel displays the new set temperature. Note that it will take time for the

refrigerator to reach the new temperature. It is normal. During this time, you need not

set the temperature again.

Using the control panel

1. Tap any button ( , , or ) to wake up the display.

2. Tap

or to select the desired menu, and then tap to conrm.

3. Tap

or to select the desired setting, and then tap to conrm.

- For more information on available settings, see the Menu descriptions section.

Dacor_RF9000A_DA68-04023L-00_EN.indd 40 2021-03-30  6:23:36