Installation Sheet

English 41
Operations
06 Filter Reset (3 sec)
Filter Reset
After about 6 months (and typically, about 300 gallons (1200 L)
of water), the Filter indicator blinks red for several seconds when
you open or close the door, reminding you that the lter needs to
be replaced.
When this happens, replace the lter, and then press and hold
Filter Reset for 3 seconds. The lter lifecycle will be reset and the
Filter indicator turns off.
NOTE
• Some regions have relatively large amounts of lime in their
water. This can reduce the lifecycle of the lter. In these areas,
you will have to replace the water lter more often than
specied above.
• If water is not dispensing properly, the water lter is most
likely clogged. Replace the water lter.
07 Energy Saver
Energy Saver
Use Energy Saver mode to reduce power consumption.
Press Energy Saver to turn on or off Energy Saver mode and
the corresponding indicator. By default, Energy Saver mode is
enabled.
NOTE
If condensation or water drops form on or around the doors, turn
Energy Saver mode off.
08 Door Alarm / °F  °C (3 sec)
Door Alarm
If the door is left open for more than 2 minutes, an alarm will
sound and the Alarm Indicator will blink. You can toggle the alarm
on and off by pressing Door Alarm. The alarm is enabled by
factory default.
°F  °C
You can also use the Door Alarm button to switch the temperature
scale between Celsius and Fahrenheit.
To switch the temperature scale, press and hold Door Alarm for
3 seconds to change the current temperature scale.
DACOR_RF8000MC_DA68-03563J-04_EN.indd 41 2020-12-11  5:16:56