User Manual

English126

Care and maintenance - Oven

5. Lower the oven door to the fully

open position. If the oven door does

not open to a full 90°, repeat steps 1

through 3.

6. Locate the oven door hinge locks in

the corners of the oven door, and

rotate the hinge locks toward the oven

cavity to the locked position. See Step

3 (illustration A) in the “Removing the

oven doors” section for the proper

locked position.

7. Close the oven door.

8. When the hinges are properly installed

and the door is closed, there should be

an even gap between the door and the

control panel. If one side of the oven

door is hanging lower than the other,

the hinge on that side is not properly

installed.

9. Reconnect the LED light’s Wire Harness

and re-insert the rubber seal.

CAUTION

After replacing the door, make sure to reconnect the wires. Push them inward to arrange

them as they were before you removed the door. Wires that are not connected or

arranged correctly can be caught in the door or damaged by heat.

NY9900M_PRO RANGE_DOP48M96DLM_DG68-00935A-00_EN+MES+CFR.indb 126 2017-05-12  7:29:08