Installation Manual

English52

Installation instructions

Re-installing the Oven Door(s)

WARNING

To avoid personal injury or damage to the door from it falling off its hinges:

• Make sure that the notch on the bottom of each hinge rests on top of the lower lip of

each hinge receptacle before attempting to open the oven door.

• Rotate the hinge locks toward the front of the range immediately after installation of

the door.

1. Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the

oven. Slide the hinges into the hinge openings, resting the bottom of the hinge arms

on the hinge receptacles. Continue to hold the door at a 15° angle with one hand while

pushing in on each of the bottom corners of the door. Push until the notch on the

bottom of each hinge slips over the lower lip of each hinge receptacle.

NOTE

Wire connector under the right side of the door should be connected.

2. Lower the door to the fully opened position.

3. Rotate the two hinge locks toward the oven.

4. Slowly and carefully open and close the door completely to ensure that it is properly

installed.

5. Remove any packaging from inside the oven(s).

Lower lip of hinge receptacle

Notch on bottom of hinge

Door Installation

Install_NY9900M_PRORANGE_DOP48M96DLM_DA_DG68-00936A-00_EN+MES+CFR.indb 52 2017-05-12  7:36:52