Installation Manual
English  51 
Installation instructions
Final installation
Back of range
Rear leg
1 1/4” *
* Distance to floor: 
4 1/16” to 5 5/16”
Anti-Tip Foot 
(location varies)
up
down
1.  Peel the protective coating off of the 
range, including the door.
2.  Measure from the floor to the 
countertop. Adjust the leveling legs as 
required to position the trim around 
the cooktop even with or above the 
countertop.
3.  Locate the anti-tip foot on the back of 
the range and lower (turn) it until it is 
1/16” (2 mm) off the floor.
Anti-tip 
bracket
Anti-tip foot
4.  Carefully slide the range into position 
into the cutout. The anti-tip foot should 
engage the anti-tip bracket. Using a 
flashlight look underneath the range 
and verify that the bracket covers the 
anti-tip foot.
5.  Use a level to make sure that the range 
does not tilt front to back or side to 
side. Re-adjust the legs to level and 
change the height if necessary.
Install_NY9900M_PRORANGE_DOP48M96DLM_DA_DG68-00936A-00_EN+MES+CFR.indb 51 2017-05-12  7:36:52










