Installation Manual

English50

Installation instructions

Before sliding the range into the cabinet:

1. Make sure the gas supply valve is in the off position and that power to the range is

off.

2. Connect a flexible gas supply line to the gas shut-off valve previously installed on the

stub out. The gas line needs to be long enough to allow the range to be pulled out for

service.

3. Slide the gas line up through the access holes in the chassis and up to the regulator.

Move the wires around inside the access holes to prevent them from catching on the

gas line as you push it up.

4. Connect the gas line to the regulator.

5. Turn all cooktop control valves to the “OFF” position. Turn on the gas supply.

6. Check all lines and connections for leaks using a soap and water solution.

7. After verifying that there are no gas leaks, turn off the gas supply valve connected to

the range to the “OFF” position.

Regulator connection

Back of range

Gas line

Install_NY9900M_PRORANGE_DOP48M96DLM_DA_DG68-00936A-00_EN+MES+CFR.indb 50 2017-05-12  7:36:52