Installation Manual

English48

Installation instructions

Installing a 4-wire conduit

• Aluminum building wire may be used but it must be rated for the correct amperage

and voltage. Connect wires according to this Step 4 depending on the number of wires.

• Wire used, location and enclosure of splices, etc., must conform to good wiring

practices and local codes.

Ground strap

Ground plate

White

Black

Red

Neutral

terminal

Ground wire

(Green)

Wire

tips

White

Black

Red

1. Loosen the 3 lower terminal screws

from the terminal block. Remove the

ground screw and ground plate and

retain them.

2. Cut and discard the ground strap. Do

not discard any screws.

3. Insert the ground bare wire tip

between the range frame and the

ground plate (removed earlier) and

secure it in place with the ground

screw (removed earlier).

4. Insert the bare wire (white/neutral)

tip through the bottom center of the

terminal block opening.

5. Insert the two side bare wire tips into

the lower left and the lower right

terminal block openings.

6. Tighten the screws until the wire is

firmly secured (35 to 50 inch-lbs.). Do

not over-tighten the screws since it

could damage the wires.

Install_NY9900M_PRORANGE_DOP48M96DLM_DA_DG68-00936A-00_EN+MES+CFR.indb 48 2017-05-12  7:36:52