Installation Manual

English24

Installation requirements

Pre-installation checklist

1. Before preparing the opening in the countertop or cabinet, verify that there will be no

conflict between the range and anything in the cabinet below.

2. Remove packing materials, grate boxes, regulator with literature, and literature

package from the range, verify that all items are present before beginning the

installation.

General requirements

Clearances and dimensions

• For OTR over Gas Stove, please follow local GAS CODE.

• BEFORE YOU BEGIN to install this appliance, refer to the following information,

dimensions, and clearances. Do not locate the range where it may be subject to strong

drafts. Provide adequate clearances between the range and adjacent combustible

surfaces. These dimensions must be met for safe use of the range. The location of the

electrical outlet and gas piping may be adjusted to meet the following dimensions and

clearances.

• The range may be installed flush to the rear wall. Dacor strongly recommends installing

a non-combustible material on the rear wall above the range and up to the vent hood

or installation of a backguard. It is not necessary to install non-combustible materials

behind the range below the countertop height. Any openings in the wall behind the

appliance or in the floor underneath it must be sealed.

• For installation in Canada, a free-standing range is not to be installed closer than 4.7 in

(12 cm) from any adjacent surface.

CAUTION

This range has been designed to comply with the maximum allowable wood cabinet

temperature of 194 °F (90 °C). Make sure the wall covering, countertops, and cabinets

around the range can withstand the heat (up to 194 °F [90 °C]) generated by the range. If

not, discoloration, delamination, or melting may occur.

Install_NY9900M_PRORANGE_DOP48M96DLM_DA_DG68-00936A-00_EN+MES+CFR.indb 24 2017-05-12  7:36:47