Installation Instructions

English44

Installation instructions

Installing the power cord

Strain relief

Power cord

Conduit connection

plate

For power cord installations, hook the

strain relief over the power cord hole (1⅜")

located below the rear of the drawer body.

Insert the power cord through the strain

relief and tighten the device.

• You must install the power cord with a

strain relief.

• Attach the strain relief to the 1⅜"

opening in conduit connection plate.

Installing a 3-wire power cord

WARNING

The neutral or ground wire of the power cord must be connected to the neutral terminal

located in the center of the terminal block. The power leads must be connected to the

lower left and the lower right terminals of the terminal block.

Ground strap

Neutral

terminal

Black

White

Red

Black

White

Red

1. Remove the 3 lower terminal screws

from the terminal block.

2. Insert the 3 terminal screws through

each power cord terminal ring and into

the lower terminals of the terminal

block. Be certain that the center wire

(white/neutral) is connected to the

center lower position of the terminal

block.

3. Tighten screws securely into the

terminal block. DO NOT remove the

ground strap connection.

Install_NY9900M_PRORANGE_DOP48M96DLM_DA_DG68-00936A-00_EN+MES+CFR.indb 44 2017-05-12  7:36:50