Installation Instructions

English40

Installation instructions

Removing the Oven Door

WARNING

• Do not attempt to disengage the hinge catches with the door(s) removed from the

range. The hinge springs could release causing personal injury.

• Do not lift or carry the oven door(s) by the handle.

NOTE

When installing a backguard, always install it before sliding the range into place. See page

34.

To make the range easier to move, remove the door(s) to reduce weight.

Catch

Retaining arm

1. Open the door to its fully opened

position.

2. Use a pair of needle nose pliers or a

flat blade screwdriver to rotate the

catch over the retaining arm on each

hinge.

Door Gripping

Points

3. Lift the oven door to about a 15°

angle from the vertical position.

4. Hold the door with both hands just

below the handle and pull it away

from the oven while continuing to

lift.

NOTE

Wire connector under the right side of

the door should be disconnected while

removing door. Slightly lift the door and

disconnect the wire.

Install_NY9900M_PRORANGE_DOP48M96DLM_DA_DG68-00936A-00_EN+MES+CFR.indb 40 2017-05-12  7:36:49