Installation Instructions

English38

Installation instructions

Installing the Anti-Tip Bracket on the Wall

1. Determine the suitability of wall mounting the anti-tip bracket. To use the wall mount

option, the range front panel must not be more than 26 1/2” (67.3 cm) from the wall

and the bracket screws must be able to thread into the base plate inside the wall

behind. The notches on the sides of the bracket indicated the minimum required height

of the base plate inside the wall and that any floor covering is not too thick for proper

screw thread engagement.

To determine if the base plate is high enough:

• Determine the location of the range center line and front panel when the range is in

its final position based on the product dimensions on page 5 and the actual cabinet/

cutout dimensions used for the installation.

• Determine and mark the required position of the anti-tip bracket, based on the diagram

above. Push the bracket up against the wall in the mounting location.

• Using a pencil, make a dot next to the notches on both sides of the bracket. Determine

if the base plate is as high at the notches by drilling test holes into the wall at both

dots with a 1/16” drill bit. Drill just deep enough to see if the bit contacts the base

plate. If the bit contacts the base plate the location will support wall installation of

the anti-tip bracket. If you do not contact the base plate, the wall mounting method

may not be used and the floor mounting method must be suitable, or the wall must be

modified so that the base plate is above the notches.

2. To install the bracket, place it against the wall in the mounting location. Using a drill

with 1/8” diameter drill bit, drill four (4) 1 5/8” deep pilot holes perpendicular to the

screw seating surfaces shown below. Attach the bracket to the wall as shown with the

four (4) included #12 x 1 ¾ screws.

Drywall

Notch

Wall

Base plate

Anti-tip

bracket

Install_NY9900M_PRORANGE_DOP48M96DLM_DA_DG68-00936A-00_EN+MES+CFR.indb 38 2017-05-12  7:36:48