Installation Manual

28 English
Installation Instructions
Reinstalling the Oven Door(s)
WARNING
To avoid personal injury or damage to the door from it falling off its hinges:
• Make sure that the notch on the bottom of each hinge rests on the lower lip of each hinge
receptacle before trying to open the oven door.
• Flip the hinge locks toward the front of the range immediately after installation of the door.
1. Grasp the oven door on both sides, and hold it at a 15° angle from the front of the oven. Slide the
hinges into their slots, resting the bottom of the hinge arms on the hinge receptacles. Maintain
the 15° angle with one hand while pushing in on each bottom corner of the door, until the notch
on the bottom of each hinge slips over the lower lip of each hinge receptacle.
NOTE
Wire connector under the right side of the door
should be connected.
2. Lower the door to the fully opened position.
3. Rotate the two hinge locks toward the oven.
4. Slowly and carefully open and close the
door completely to ensure that it is properly
installed.
5. Remove any packaging from inside the
oven(s).
H
inge
slot
Notch
(h
in
ge
bottom)
Adjusting the Do
or (DOP48M96D only)
Steps 1 and 3
Steps 1 and 3
Ensure the oven doors are parallel and flush. To
do this, use the three bolts (one on the right-
upper side, and one under the each hinge) .The
upper bolt adjusts the door hori
zontally. The
lower two bolts adjust th
e door vertically.
To adjust door vertically:
1. Remove the
door, then remove 2 screws on
each door-hinge latch.
2
. Adjust the bolt under each latch.
3. Re-attach and tighten the 2 screws.
4. Re-install the door.