Installation Manual

ManualsBrandsDacor ManualsCooking Appliances48 Inch Freestanding Professional Dual Fuel Smart Range with 6 Sealed Burners, Double Oven, 6.6 Cu. Ft. Total Capacity, Steam, Self-Clean, Dual-Stack Burners, and Electric Griddle: Graphite Stainless Steel, Natural Gas/High Altitude

Table Of Contents

Blank Page

26 English

Installation Instructions

Installing the Flexible Conduit, cont.

Installing a 4-wire conduit

• Aluminum building wire may be used but it must be rated for the correct amperage and

voltage. Connect wires according to this Step 4 depending on the number of wires.

• Wire used, location and enclosure of splices, etc., must conform to good wiring practices and

local codes.

Ground strap

Ground plate

Red

Neutral

terminal

Ground wire (Green)

Wire

tips

White

Black

Red

1. Loosen the 3 lower screws on the terminal

block. Remove and retain the ground screw

and ground plate.

2. Cut and discard the ground strap. Do not

discard any screws.

Insert the ground bare wire tip between the

range frame and ground plate (removed

earlier), and secure it with the ground screw

(removed earlier).

Insert the wire (white/neutral) tip through

the bottom center of the block opening.

Insert the left and right wire tips into their

respective block openings.

Tighten the screws to 35 – 50 in.-lbs.(Any

tighter may damage the wires.)

Black

White

Gas Connection

WARNING

• Turn off the gas-supply valve, and turn off power to the range at the circuit breaker or fuse box

before connecting the gas line.

• Do not apply excessive pressure when tightening gas connections and fittings.

• Do not use Teflon tape or plumber’s putty on gas flex-line connections.

• Maximum gas-supply pressure to the regulator must not exceed ½ psi (pounds per

square inch)

or 3.5 kPa.

• The range and shut-off valve must be disconnected from the gas-supply piping for pressure

testing that exceeds ½ psi (3.5 kPa).

• The range must be isolated from the gas-supply piping by closing the shut-off valve for pressure

testing at or below ½ psi (3.5 kPa).

•

Check all gas lines for leaks as instructed to avoid fire/explosions hazard. Do not check for leaks

with a flame.

NOTE

The gas-pressure regulator is factory set for the type of gas used with the range. To verify that the

range is compatible with the available gas, see the rating label (oven left door trim). Consult your

dealer if the range is incompatible with the supplied gas.