Installation Manual

Table Of Contents
Installation Instructions
SimmerSear Assembly
Keyed Hole
Locating
Tab
Burner
Base
Burner
Head
1. Put the burner heads in place as shown. The
locating tab on the burner head goes in the keyed
hole as shown.
Tabs Slots
Burner
Ring
2. Put the burner rings on the burner heads as shown.
Match the tabs on the bottom of the ring to the
slots on the head. Twist each ring back and forth
slightly to verify it is properly seated.
Ridge on
Bottom of
Burner Cap
3. Put the burner caps on the burner rings. Use
either the supplied brass or porcelain caps. The
ridge around the bottom edge of the cap goes
around the top of the burner ring.
WARNING
Be sure electrical power is off and all surfaces are cool before cleaning any part of the cooktop.
32 English