Installation Manual

22 English
Installation Instructions
Installing the Anti-Tip Bracket and Foot, cont.
Wall-Mounting the Anti-Tip Bracket
For this option to be suitable, the range front panel must be 26 1/2" (67.3 cm) or less from the
wall, and the bracket screws must be able to engage the base plate inside the wall. Notches on
the sides of the bracket indicate the minimum height of the base plate and that any floor
covering thickness will not impede secure threading.
To determine if the base height is suitable:
• Determine the location of the range centerline and front panel when the range is in its final
position based on the product dimensions on Pg. 14 and the actual cabinet/cutout
dimensions used for the installation.
• Determine and mark the required position of the anti-tip bracket, based on the diagram on
Pg. 21. Push the bracket up against the wall in the mounting location.
• With a pencil, make a dot next to the notches on both sides of the bracket. Determine if the
base plate is as high as the notches by drilling test holes into the wall at both dots with a
1/16” drill bit. Drill just deep enough to see if the bit contacts the base plate. If there is
contact, the location will support wall installation of the bracket. If there is no contact, wall
mounting is unsuitable, and either floor mounting must be used, or the wall must be altered
so there is base material above the notches.
To install the bracket, place it against the wall in the mounting location. Using a drill with 1/8"
diameter drill bi
t, drill four (4) 1 5/8” deep pilot holes perpendicular to the screw seating
surfaces shown below. A
ttach th
e bracket to th
e wall as sh
own with the four (4) included #12 x 1
¾ screws.
Drywall
Notch
Wall
Base plate
Anti-tip
bracket