Installation Manual

ManualsBrandsDacor ManualsCooking Appliances48 Inch Freestanding Professional Dual Fuel Smart Range with 6 Sealed Burners, Double Oven, 6.6 Cu. Ft. Total Capacity, Steam, Self-Clean, Dual-Stack Burners, and Electric Griddle: Graphite Stainless Steel, Natural Gas/High Altitude

Table Of Contents

Blank Page

Installation Instructions

Floor-Mounting the Anti-Tip Bracket, cont.

English 21

• Determine the required position of the anti-tip bracket, based on the diagram below. Mark the

4 mounting-hole locations on the floor with a pencil.

• Determine the screw size. The minimum full thread depth (portion of screw threaded into

wood/slab) is 3/8” (1 cm) for wood and 5/8” (1.6 cm) for concrete. (See SCREW SIZE table,

below, for correct screw sizes.)

Attaching the Bracket to a Concrete Floor

1. Drill four 3/8” dia. countersink holes through flooring to but not into the concrete.

2. Through these holes, drill 4 anchor holes 1-1/4” (3.2 cm) into the concrete with a 3/16”

masonry bit. This hole length is longer than the anchor. Clean out the holes, and tap in each

anchor so its top is flush with the concrete surface.

3. Align the bracket and anchor holes, then insert and tighten the screws.

Attaching the Bracket to a Wood Floor

1. Ceramic, stone, other hard flooring over wood: Drill 4 countersink holes to access the

wood for drilling pilot holes.

2. Drill 4 pilot holes in the wood with a drill bit (1/16” dia. for #8 screws, 1/8” dia. for #12

screws). Align the bracket and pilot holes, then insert and tighten the screws.

TOP

VIEW

Range center line

#8 x 1” #8 x 1 1/4”

or #12 x 1 3/4 screw,

4 places (see text)

Anchor, 4 places:

use for concrete

floor only

Range

front panel

SCREW SIZE

Sub-Floor Type/Floor Covering Thickness Screw Size

Concrete/wood subfloor, no floor covering

over top

#8 x 1*

Concrete/wood subfloor, floor covering up to

1/4” thick

Concrete/wood subfloor, floor covering over

1/4” up to 1/2” thick

#8 x 1 1/4*

Wood sub-floor, floor covering over 1/2” and

up to 1 3/16” thick

#12 x 1 3/4*

Concrete under floor covering over 1/2” thick

Purchase

separately**

Wood under floor covering over 1 3/16” thick

*Included with range;

**determine required depth

based on info in Step 3, and

purchase from hardware store.

ANTI-TIP BRACKET PLACEMENT

Dim.

DOP36M94D DOP48M96D

13” (33.0 cm) 3 1/2” (8.9 cm)

22 1/2” (57.2 cm) 22 1/2” (57.2 cm)