User Guide

English 45
Care and maintenance
Removing your oven’s convection lter
When the oven is cool, put your ngers
around the edges of the lter and gently
push up.
To clean the lter
Soak it in hot, soapy water. Rinse well. You may also place it in a dishwasher on
the top rack. Dry the lter before re-installing it.
Installing your oven’s convection lter
Clips
Carefully hook the metal clips on the back
of the lter over the metal bar across the
fan hole. Make sure it is centered over the
hole. Be careful not to scratch the porcelain
surfaces with the back of the lter
Care and maintenance
Care and cleaning of the oven
Cleaning painted parts and decorative trim
For general cleaning, use a cloth with hot, soapy water.
For more difcult residue and built-up grease, apply a liquid detergent directly
onto the area and leave for 30 to 60 minutes. Wipe with a damp cloth and dry.
Do not use abrasive cleaners on any oven surface. They can be scratched.
Clean soil from the porcelain surfaces of the door outside of the door gasket.
Rinse surfaces well with a solution of vinegar and water, then wipe dry.
Heavily soiled areas may be cleaned with a non-scratching scouring pad.
Cleaning stainless-steel surfaces
1. Shake a bottle of stainless-steel Appliance Cleaner or Polish well.
2. Place a small amount of stainless-steel appliance cleaner or polish on a damp
cloth or damp paper towel.
3. Clean a small area, rubbing with the grain of the stainless steel if applicable.
4. Dry and buff with a clean, dry paper towel or soft cloth.
5. Repeat as necessary.
NOTE
Do not use a steel-wool pad. It will scratch the surface.
If a mineral oil-based stainless-steel appliance cleaner has been used before to
clean the appliance, wash the surface with dishwashing liquid and water prior
to using the stainless-steel appliance cleaner or polish.
Convection lter
The convection lter is located in the back of each oven chamber.
Clean the lter regularly. If you allow it to become clogged, the oven’s convection
cooking modes will not work properly.
You also need to remove the lter during the self-clean cycle.
NOTE
For your safety and proper oven performance, re-install the lter before using the
oven to cook. If you don’t, the spinning fan blades at the back of the oven will be
exposed.
DOB30P977S_AA_DG68-01312A-00_EN+MES+CFR.indb 45 2020-07-07 �� 5:26:23