Installation Distinctive Model DCT365 Pa_ No. I06927 Rev.
Important Safety Instructions .......................................... Important Information About Safety Instructions .............. General Safety Precautions ............................................. Installation Specifications ................................................ Product Dimensions ......................................................... Electrical Requirements ................................................... Gas Supply Requirements ...............................................
Important Information About Safety Instructions The Important Safety Instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. • WARNING TO REDUCE THE R SKOF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE: a: SMOTHER FLAMESWith a €10se:fitting iid; c0okie sheet or metal tray, then turn off the burner.
General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual completely before operating this appliance. • Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately contact your dealer or builder. Do not install or use a damaged appliance.
WARNING observe further all governing codes and ordinances during planning I and installation: Contact your lOcal building informationl department for I l Product Dimensions All tolerances +1116" (+1.6 ram) unless otherwise noted. 36" countertop 2" (5.1 cm) _.f_ to cooking surface -. 4" (10.2 cm) chassis height (53.3 cm) Rear overhang Front . . (, (3.0.cm)I overhang 1 " 1 /32 J I t ,/ "', I/ II 1 " 1 /32 (1.3 cm) (34L_ _,. _ J I (34.cm) 33 %6"(84.
Electrical Requirements Gas Supply Requirements Be certain that the cooktop being installed is correct for the gas service being provided (natural gas or LP gas). Also, if operating the cooktop at an altitude above 4000 ft. (1219 m) make sure it is equipped for high altitude operation.
Allow a minimum ¼" (6 mm) clearance between the bottom of the cooktop chassis and all combustible surfaces, including the upper edge of a drawer installed below the cooktop. Cabinet and Countertop Layout WARNING ' Failure to meet or exceed the maximum and mini' mum dimensions/clearances tions may result ina fire hazard: Follow the c0untert0p manufacturer s instructions regarding the minimum corner radius, use of heat reflective tape, reinforcement of corners, etc.
Cutout Dimensions All tolerances +1/16"-0 (+1.6 mm, 0) unless otherwise noted. Rear wall Vertical combustible surface 4 ¼" (10.8 cm) min. from mounting surface to combustibles below cooktop chassis E D Minimum distance to combustible side wall above countertop (both sides) (C) Minimum (D) (E) 3 %" (8.3 cm) 19 5/8" (49.9 cm) 33 5/8" (85.4 cm) Countertop 6 _mC_ Cutout Dimensions (F) Minimum 6 7/8" (17.
Verify Package Contents • Hold down brackets (2) • Grates (3) • Burner sets (5) • Gas pressure regulator with ¾" to ½" reducer • Stainless steel cleaner Connecting the Gas Line WARNING • Verify that the gas supply meets specifications before connection. See page 4. • Do not install the cooktop without also installing the included gas regulator. Do not use the cooktop without the regulator installed.
Installing the Burner Components WARNING Never attempt t0 operate the cooktop with any of the burner parts removedl , , , , Left grate, curved fingers on left Slot on bottom Center grate Slot on bottom Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory ....... Remove the burner rings, burner caps and grates from their shipping packages. Slot on bottom / Assemble the burners as shown. Match the burner parts to the correct size and type of burner.
NOTE: If the cooktop does not operate properly, these troubleshooting steps: Verifying Proper Operation ] WARNING Make sUre that power to the electrical outlet is turned off at the circuit breaker panel or fuse box and that the gas is turned off at the gas supply valve before proceedingl 'ii The C0oktop must be Pr0perly grounded at all times when electrical power is applied: Prior to operating the cooktop, read the accompanying and care manual carefully. 1. , 3.
Installation Checklist WARNING To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor cooktop cannot be overemphasized, [] Is the electrical outlet for the cooktop grounded and located according to these instructions and in accordance with all applicable electrical codes? See page 4.
WARNING Label all wires prior to dislconnection When servicing Controlsl Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing 120 Vac, 60 Hz.
12 c_acar
® The Life of the Kitchen? Dacor • 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 • Phone: (800) 793-0093 • Fax: (626)403-3130 Family Owned American Made • www.Dacor.
