Specifications

Hanging the Range Hood
1. Attach the hood junction box to the top of the hood
using two machine screws as shown.
,
On models with two blowers: Put the exhaust cowling
over the blower outlets on the top of the hood. Fasten
the cowling in place with 14 machine screws.
, I_
,, ,T , ', , I_
I I _I I I_
I I II I
i I II
i I II
i I II
i I II
i I II
II
II
II
II II ii
II II ii
II II ii
II II ii
II II ii
II
II
,
,
Remove the filter(s) to reduce weight and avoid dam-
age.
Lift the hood up on both sides and put the mounting
hole on the top of the hood over the lip of the mount-
ing bracket. Gently lower it into place.
.- "._j Mounting
bracket
,
Inside the exhaust outlet(s) there are metal or plastic
damper flaps. The flaps close to help prevent back-
drafts when the blower is turned off. Remove the
shipping tape and make sure all the flaps open and
close freely before proceeding.
,
,
Insert two provided machine screws into the two
holes above the mounting bracket on the range hood.
Tighten the screws until they make contact with the
bracket, then tighten them as necessary to make
minor leveling adjustments to the hood.
Insert two machine screws through the front of the
mounting bracket and tighten them into place.
_mCD_ 7