Installation guide

Step 2
Place a towel or table cloth onto the counter top. Lay
the cooktop upside down onto the protected surface.
BURNER BOX
TABLE CLOTH
Figure 6
Step 3
A foam tape is provided to seal the cooktop edges to
the countertop.
Apply tape approximately 1/16" (1.5 mm) from the
glass edge to the underside of the cooktop glass. Use
tape around the entire glass perimeter. Cut off excess
where tape ends buit.
BURNER BOX
FOAM TAPE
SEAL
COOKTOP GLASS
Figure 7
Step 4
Insert the cooktop centered into the cutout opening. Make
sure the front edge of the counter top is parallel to the
cooktop. Make final check that all required clearances are
met.
cms
Figure 8
Step 5
Four clamp brackets are provided to clamp the cooktop to
the countertop. Tighten screws just enough to hold brackets
in place when cooktop is put into cutout. Tighten screws
securely.
Figure 9