cdacor ee See Installation Distinctive Series Cooktop Models DCT305, DCT365 Part No. 106927 Rev.
Table of Contents Important Safety INStructiONS ...........cccecccecscstcrsrsrsrereeeeeee important Information About Safety Instructions............. General Safety Precautions 0.0.0.0... cccccccccccccccccceeeeeeeeeeneees Installation Specifications. .............sccececcseesrsrsrsssrsssrereeeee Product DIMENSIONS ....... ccc ccccececeeeeecececccecceceeeeeeeeeneneees Electrical REQUIFEMENIS 0.0... cette teetteeeceseeeeeeeeees Gas Supply Requirement ..........0...
Important Safety Instructions mportant Information About Safety Instructions WARNING TO REDUCE THE RISK-OF INJURY TO. PERSONS THE EVENT OF A RANGE TOP.GREASE FIRE: The important Safety Instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when including the following: using this appliance, follow basic safety precautions, WARNING Read: the accompanying use and care manual completely before operating this appliance. Keep. packaging materials away from children. Plastic sheets and bags can cause. suffocation. If you receive a damaged product, immediately contact -your.dealer or.builder.
Installation Specifications WARNING Observe.all governing codes:and. ordinances. during planning and installation’. Contact-your local building department. for further.information. Product Specifications All tolerances +1/16” (£1.6 mm) unless otherwise noted. 2" (5.1 cm) countertop to cooking surface a o~ 4" (10.2 cm) chassis height Model (A) (B) DCT305 | 30” (76.2 cm) | 27 5/16” (69.4 cm) DCT365 | 36” (91.4 cm) | 33 5/16” (57.8 cm) Rear Front overhang 13/16" (3.
Installation Specifications Electrical Requirements WARNING To prevent.an electric shock hazard, the power-supply must meet the specifications stated below, It. is the owner’s responsibility to make_sure that the electrical service meets electrical requirements and that the electrical outlet has-been properly installed by-a ‘licensed-electrician. * * The cooktop is supplied with a factory installed, 42 inch long, power cord with a three-prong, grounding electrical plug.
Installation Specifications Cabinet and Countertop Layout Allow a minimum 1/4” (6 mm) clearance between the bottom of the cooktop chassis and all combustible surfaces, including the upper edge of a drawer installed below the cooktop. WARNING «Failure to meet or exceed the maximum and minimum dimensions/clearances stated: in these instructions may.result in a fire hazard. «Follow the countertop:manufacturer’s instructions regarding the minimum.
Installation Specifications Cutout Dimensions All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted. Vertical combustible SQ surface Nw A 4 1/4” (10.8 cm) min. from mounting surface to combustibles below cooktop chassis 1 5/8” wine hae (4.1 cm) Minimum distance to combustible side wail above countertop (both sides) Countertop Cutout Dimensions Installation Type (C) Minimum (D) (E) DCT305* 3 1/4” (8.3 cm) 19 5/8” (49.9 cm) | 27 5/8” (85.4 cm) | 6 7/8” (17.
Installation Verify Package Contents Hold down Instructions Connecting the Gas Line brackets (2) WARNING Grates (3) Verify that the gas supply -meets specifications before connection. See page 4. Burner sets (5) Gas pressure regulator with 3/4” to 1/2” reducer Do-not install the cooktop without also installing the included gas regulator. Do not use the cooktop without the regulator installed.
Installation Instructions Installing the Burner Components WARNING *. Never-attempt to. operate the cooktop with any-of the burner. parts removed. «. Do not-attempt to adjust the burner.air-mixture settings. All adjustments are preset at the factory. 1. Remove the burner rings, burner caps and grates from their shipping packages. 2. Assemble the burners as shown. Match the burner parts to the correct size and type of burner. When installing the burner components, make sure they are centered.
Installation Instructions IMPORTANT: Install the grates as instructed below for longest life. When installed properly, the openings in the grates are centered over the burners. 3. Locate the notch on the bottom of each grate. 4. Use the notch on the bottom location and orientation. See on the bottom of each grate the cooktop. The notches on toward the outside. 5. Gently lower the legs of each grate into the corresponding dimples on the cooktop. of each grate to determine diagram below.
Installation Instructions Verifying Proper Operation NOTE: If the cooktop does not operate properly, follow these troubleshooting steps: Verify that power and gas are supplied to the cooktop. WARNING Make sure that power to the electrical outlet is turned off.at the circuit breaker panel or fuse box and-that the gas is-turned_-off-at the gas supply valve before proceeding. The cooktop must be properly grounded at all times when electrical power is applied.
Installation Instructions Installation Checklist WARNING *. -To-ensure a safe and: proper: installation, the following checklist should -be completed by the installer.to ensure that no-part of-the installation has been overlooked. °--Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor cooktop cannot be overemphasized.
Wiring Diagram WARNING Label all wires prior to dis-connection when servicing controls. Wiring errors:can cause improper. and dangerous-operation. Verify proper operation after servicing 120 Vac, 60 Hz. power supply wf] BK G IGNITERS eR = FR o $5 GND MC $4 FL 5 POINT $3 RL RE-IGNITER S2 q a pk 89 BK ~~ |_4 3 os 3K be be Wy RR LIGHT UD dacor.
oecor The Life of the Kitchen® Dacor e 600 Anton Bivd. Suite 1000 Costa Mesa, CA 92626 @ Phone: (800) 793-0093 e Fax: (626) 403-3130 Sar American Made TICLE gO « www.dacor.
