Specifications

9
Level the Dishwasher
CAUTION
A level unit is very important for proper operation. Be sure
to level the unit front to back and side to side.
Measure the height of the cabinet opening from the 1.
underside of the countertop to the floor.
Move the dishwasher to the front of the installation 2.
area.
Use the included spanner wrench to adjust the leveling 3.
legs. Make sure the dishwasher height fits into the
enclosure with 1/4” clearance at the top.
Open the door and remove the bottom rack. Check that 4.
the dishwasher is level from front to back by placing a
level inside, on the bottom of the tub. Check to make
sure the dishwasher is level side to side by placing the
level on the top front of the tub.
Adjust the legs up or down until the dishwasher is level.5.
Locate the foam support between the motor and the 6.
liner on the bottom of the unit. Use two hands to rotate
and slide the foam down and to the left to remove it.
Discard the foam.
Remove the four (4) screws at the front of the access 7.
cover. Tilt the access cover and pull it forward to
remove it.
Locate the water inlet 8.
valve on the bottom of the
dishwasher. It has a 3/8”
NPT female fitting. Wrap
the threads on the 90°
elbow (not included) with
thread seal tape or apply
joint compound. If using
tape, wrap it in the same
direction as the elbow
threads. Thread the elbow
into the water inlet valve.
Tighten the elbow with a 9.
wrench, leaving it pointing
toward the rear of the
dishwasher. To prevent
damage, do not over
tighten.
Installation Instructions
Top front of tub
Level
Foam support
Access cover
Junction box