Installation Instructions 24 - Inch Built-in Dishwasher For use with models: EDW24S, MDW24S Part No. 101586 Rev.
Table of Contents Important Safety Instructions........................................... 1 Important Information About Safety Instructions............... 1 Safety Symbols and Labels.............................................. 1 General Safety Precautions.............................................. 2 Installation Specifications................................................. 3 Product Dimensions.......................................................... 3 Preparing the Location.........................
Important Safety Instructions Important Information About Safety Instructions • • Safety Symbols and Labels The Important Safety Instructions and warnings in this manual are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. Always contact the Dacor Customer Service Team about problems and conditions that you don’t understand.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: Warning • Do not install or operate this dishwasher if it has been damaged, dropped, has damaged electrical conduit or wires or is not working properly. If the product is damaged when received, immediately contact the dealer or builder.
Installation Specifications Product Dimensions Product tolerances: ±1/16” (±1.6 mm), -0, unless otherwise stated 23 7/8" (606 mm) adjustible to 24 1/4" (616 mm) 14 5/8" (371 mm) From rear to junction box 3 1/4" (83 mm) from side to water inlet 4" (102 mm) from side to junction box 12" (305 mm) From rear to water inlet Handle style varies with model number.
Installation Specifications Preparing the Location warning Electric Shock Hazard - Electrical, water and drain lines must be confined to the shaded areas shown below to prevent damage. Failure to follow these instructions could result in fire, electric shock or property damage. • Carefully check the location where the dishwasher is to be installed. Put it in a location with convenient access. • Plan the installation so that the appliance can be removed if service is required.
Installation Specifications Plumbing Requirements • Drain Connection IMPORTANT: A 72” drain hose is supplied with the product. Should a longer drain hose be required, use a hose approved for detergents and high temperature water. The drain hose supplied with the dishwasher meets an AHAM DW-1 test standard. Longer drain hoses should not be longer than a total of 10 ft. in length. • • Review the different ways shown to connects the dishwasher to the drain system.
Installation Instructions Verify the Package Contents Materials required for installation (not provided): • Cut the shipping carton open and use it as a pad beneath the dishwasher until the legs are installed. With the assistance of at least one person, place the unit to the side of the cabinet opening.
Installation Instructions Electrical Connection 1. Make sure power to the house junction box is off. 2. Cut an access hole for the wiring in the shaded area shown in the cabinet diagram below. warning • • Do not install the dishwasher unless the electrical service provided meets the dishwasher specifications (see page 4). To avoid an electrical shock hazard, turn off power to the junction box at the circuit breaker panel or fuse box before proceeding.
Installation Instructions Plumbing Connections Preparing the Dishwasher for Installation warning Do not cross the drain, water and electrical lines in front of the dishwasher motor or frame. 1. Cut the hot water supply line access hole in the cabinet as shown below. 1. Uncoil the drain hose in the back of the dishwasher. 2. Do not remove the rear insulation blanket. 3. With the help of at least one other person, lay the dishwasher on its back. Do not kink or crush the drain hose. 4.
Installation Instructions 6. Locate the foam support between the motor and the liner on the bottom of the unit. Use two hands to rotate and slide the foam down and to the left to remove it. Discard the foam. Level the Dishwasher caution A level unit is very important for proper operation. Be sure to level the unit front to back and side to side. 1. Measure the height of the cabinet opening from the underside of the countertop to the floor. Foam support 2.
Installation Instructions Positioning the Unit in the Cabinet warning • Be careful not to pinch the wiring, hot water line and drain hose as you push the dishwasher into place. An electric shock hazard or water damage may result from pinched wires or hoses. Damage due to improper installation is not covered under the warranty. • Do not push against the front panel with your knees while positioning the dishwasher.
Installation Instructions Finish the Electrical Connection Verifying Proper Operation warning Electric Shock Hazard - Make sure electrical power has been turned off at the circuit breaker panel or fuse box. WARNING • To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked and the unit is working properly. • Proper installation is the responsibility of the homeowner.
Installation Instructions Verifying Proper Operation, Cont. If the dishwasher fails to operate properly: Wet Test Check List • Verify that power is supplied to the dishwasher. • Check all plumbing connections. • Repeat the verification test. • If the appliance still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not attempt to repair the appliance yourself. If you need service, be sure to have the model and serial numbers available when you call.
Installation Instructions Attaching the Unit to the Adjacent Cabinets 1. Remove the (2) plastic plugs on each side of the inside of the dishwasher frame. 2. Drill pilot holes into the adjacent cabinets for the provided mounting screws. Adjusting the Stainless Steel Trim Plates 3. Secure the anti-tip brackets on both sides to the cabinets using the provided screws as shown. Your Dacor dishwasher has been equipped with adjustable stainless steel side trim plates.
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.
