Specifications

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

FM Radio

Note:

If you ﬁ nd that FM reception is poor, try repositioning the wire aerial.Fully

extend the wire aerial for optimum reception. If you ﬁ nd that an FM broadcast

has a lot of background hiss, this may often be reduced by setting the

radio into Mono reception mode for the current FM station. Please refer

to the section 'Stereo / Mono setting - FM' on page 22 for further details.

If the received station is received in stereo the stereo icon

will show

on the display.

Manual tuning - FM

1. Fully extend the wire aerial located on the rear of your sound system.

Place the wire antenna so that it is as straight as possible extending

either above or below the sound system.

2. Press and release the On / Off button to switch on your sound system.

3. Press and release the Function button until the FM mode is selected.

4. Repeatedly press and release the Tuning Up or Down buttons to

tune to a station. The frequency will change in steps of 50kHz.

If the radio is tuned to a station of sufﬁ cient signal strength with RDS

information present, then the display may change to show the station

name.

5. When the end of the waveband is reached the radio will recommence

tuning from the opposite end.

6. Set the Volume to the desired setting.

7. To switch off your sound system press and release the On / Off button.