Phau Ntawv Qhia

Page 3

1. Remove the cover ② from the base plate ①.

2. Hold the base plate ① against the wall at the desired loca-

tion and mark the four drill holes horizontally.

3. Drill holes with a diameter of 8 mm in the wall at the

marked positions.

4. Insert four masonry plugs ⑥ in the drill holes.

5. Run the speaker cable through the holes in the base plate

① from below.

②⑤ ①⑥

Speaker cable

6. Screw the base plate ① on the wall using four half round

head screws ⑤.

7. The cover ② is marked with “TOP” and “DOWN” inside.

Run the upper end of the speaker cable through the upper

hole in the cover ②.

8. Put the cover ② on the base plate ①. In the process, the

speaker cable must be run through the notches on the

front and bottom side.

9. Place the bracket ③ on the base plate ① and insert the

carriage bolt ④ from above. Ensure that the square of the

carriage bolt exactly ﬁ ts into the square hole of the bracket

③.

④

①

⑨

⑦

③

10. Tighten the carriage bolt ④ with the washer ⑨ and the nut

⑦.

11. If necessary, loosen the screws ⑪ and change the inclina-

tion of the bracket ③.

To align the wall mount horizontally, loosen the nut ⑦,

align the bracket ③ with the listening zone and tighten the

nut ⑦ again.

③

⑪

⑦

12. Screw tighten the speaker on the bracket ③ using the

screw ⑧.

⑧

③

Assembly