Phau Ntawv Qhia

Page 4
5. Connect the cable to the speaker.
6. Place the speaker with the bottom bracket on the bottom
bolt (a).
7. Push the tube b up until the holding screw runs stops in
the upper bracket.
8. Use the cylinder screw e to secure the tube.
9. Then tighten the countersunk head nut (b).
Assembly of the speaker stand for micro-speakers
e
[
1. Screw the tube
onto the base plate
with two cylinder
header screws
. Align the tube so that the bolt is facing
forward.
2. Run the speaker cable either through the bottom hole in
the base plate (example A) or through the lower opening in
the tube (example B). Pull the cable through the tube until
it extends out of the upper oval opening.
b
a