INSTRUCTION BOOK FOR Senior Electrol®
Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized service dealer when repair work is required. Incorrect reassembly can cause electric shock when the appliance is used subsequently. 2.
Installation NOTE: Unit is not to be installed in air handling space. 1. Level unit lengthwise with a carpenter's level and plum level. CAUTION! Do not completely seal in unit. Access room must be allowed for motor repair or fabric replacement. ATTENTION! Ne fixez pas complètement l'unité. Un espace doit être laissé pour pouvoir réparer le moteur ou remplacer la toile. 2. Remove shipping brace by removing 3 hex head screws (Fig. 2). CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool.
Picture Surface Rolled Up Or Closed Position NOTE: Adjustments should not be necessary to screen in the rolled up or closed position. If necessary, use the following procedures: Picture Surface Rolls Too Far Into Case Picture Surface Does Not Roll Completely Into Case 1. 1. Lower picture surface approximately two feet with operating switch. Place operating switch in “up” position. 2. Turn the “up” limit knob one-quarter turn counterclockwise. 2. Place operating switch in “off” position. 3.
Senior Electrol® Instructions For Screens 20' And Larger In Height Or Width For Screens Up To 18' X 18' Motor Compartment 9 1⁄2" Motor Compartment Lengt Reinforced h = Fa b r Top ic W + 23", A id ll Sizes th 11 5⁄16" 18 5⁄8" 10 3/4" Leng Width th = Fabric + 23", A ll Sizes 12 9⁄16" Reinforced Top Hinged Access Panel 18 5⁄8" For Motor Compartment Hinged Access Panel For Motor Compartment 4 3⁄8" Fabric Height x Width As Ordered, Up To 20 Feet x 20 Feet Or Up To 12 Feet High x 24 Feet Wide Fabric
Troubleshooting Visit www.da-lite.com to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at Symptom info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Cause Solution Blown fuse. Replace fuse. Tripped circuit breaker. Reset circuit breaker. Tighten all loose wire connections. Correct any improper connections. Check for power.
Troubleshooting Symptom Cause Solution Blown fuse or tripped circuit breaker. Replace fuse or reset circuit breaker. No power between red and white leads in junction box. Correct improper wiring. Screen will not move “up.” Thermal overload tripped. Let motor cool for 15 minutes. Try again. Motor does not hum. Burned out motor winding. Check for power between red and white motor leads. Replace motor if there is power. Motor hums. Temporary binding.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory.
