User Manual

13
2. Install electrical connections. Make sure to review the wiring diagram for proper hook up as shown in Figure 26.
NOTE: Must be installed in accordance with the requirements of the
Local Building Codes, the Canadian Electrical Code (CEC), CAN/CSA C22.1
and the National Electric Code (NEC), NFPA 70. An appropriate disconnect
device shall be provided as part of the building installation.
Multi Format Imager Wiring Diagram
1. To connect power to unit locate junction box cover on bottom frame assembly. There will be two black screws holding the wiring
box cover on as shown in Figure 25.
Figure 25
Figure 26
RJ45
Remove Two
Screws Holding
Junction Box
Cover
Left Motor
Input
120V / 60Hz
RJ45
Coupler
RJ45
Coupler
Three Conductor
Power Wire
Green
(Ground)
Right Motor
6P6C
RJ22 Cable
From QAUX
To QEYE
Quick Connect
Motor Plug
Quick Connect
Motor Plug
8P8C
RJ45 Cable
Black
(Hot)
White
(Common)
+12V
Manual 2
Ground
Manual 1
RQ Clock
Bus (RP Data)
RQ Data
+5V
Blue
Green
Yellow
Red
Black
Orange
Purple
Brown