manual

Hardware Kits
A101, A105, A109, A111
Form E-364
Rev. 08 / 10
Caution: These fasteners should be installed by
qualified personnel into a surface that is capable of
supporting a static load of four times the combined weight
of the audio/visual device and mount. Do not attach to
plaster, paneling or drywall alone.
Required Tools:
- 9/16” wrench
- Drill motor
- Drill bits
- Hammer
Solid Concrete Hardware Kit –A101
1. Remove contents from carton and
examine for damaged or missing parts.
See Figure 1.
2.
Drill a 5/8” diameter hole into the concrete
wall surface to the screw length. Blow the
hole clean of dust and debris.
3. Make sure the threaded cone is snug
onto the anchor so that the cone will stay
on the anchor during installation. Insert
the anchor, cone first, into the hole and
tap it in place so that the top edge is flush
with the concrete surface.
4.
Position the mount and insert the screw to
engage the cone and tighten the screw
until secure. The screw should engage a
minimum of 2/3 of the threads. Use a flat
washer where applicable.
Figure 1