Manual
2
1.  The case provides multiple attachment points for bolts, 
cables, or threaded rod. Page 8 shows threaded rod installed. 
The variable position-mounting bracket may be located 
anywhere along the length of the case. It is recommended  
to keep the brackets spaced evenly enough to distribute the 
weight of the screen.
  The case has a self-trimming lange around the bottom. 
Ceiling tiles or drywall may be placed on top of this lange  
to provide a inished appearance.
2.  After securing the case in the ceiling check that the case  
is level and plumb.
3.  Install electrical connections that apply to your unit. Refer to 
the following diagrams for proper installation. The diagrams 
on page 5 are for standard controls; the diagrams on page 6 
are for SCB100 controls and page 7 for SCB200 controls. The 
terminal block for the wall switch connections is located 
under the metal housing surrounding the junction box. 
Remove two screws for access.
Case Installation
Important Safety Instructions
When using your video equipment, basic safety precautions 
should always be followed, including the following:
1.  Read and understand all instructions before using.
2.  Position the cord so that it will not be tripped over, pulled,  
or contact hot surfaces.
3.  If an extension cord is necessary, a cord with a current rating 
at least equal to that of the appliance should be used. Cords 
rated for less amperage than the appliance may overheat.
4.  To reduce the risk of electric shock, do not disassemble this 
appliance. Contact an authorized service dealer when repair 
work is required. Incorrect reassembly can cause electric 
shock when the appliance is used subsequently.
5.  The use of an accessory attachment not recommended by 
the manufacturer may cause a risk of ire, electric shock,  
or injury to persons.
Save These Instructions
Pre-Installation
1.  Carefully unpack screen and remove outer wrapping  
from case.
2.  Make sure to recheck measurements of screen location 
before installation.
Figure 1
Fabric Door
Access 
Door
Screw For 
Securing Roller 
Access Door










