Manual

5
SCREEN ADJUSTMENT
Screen travel is stopped automatically in the down and up
p
ositions by the limit switches that are preset at the factory. If
it’s necessary to adjust for more or less drop follow the steps
below. The case cover must be removed to access the motor
limit switches.
Remove the case cover screw from both ends of the screen.
See figure 4. Be sure to hold the cover while removing the
screws.
Rotate the cover up and away from the case until it can be
removed.
SETTING THE DOWN LIMIT POSITION
TO REDUCE SCREEN DROP:
Turn the red limit switch screw clockwise to decrease the
amount of screen drop. Run the screen down to test the
stop position. If the screen drops too far, raise the screen
about one foot and adjust the limit switch again. Repeat
until the desired position is set.
TO INCREASE SCREEN DROP:
Turn the red limit switch screw counterclockwise to
increase the amount of screen drop. Run the screen
down to test the stop position. If the screen does not
drop enough, raise the screen about one foot and adjust
the limit switch again. Repeat until the desired position is set.
CAUTION: Do not adjust for more drop than what was ordered. At least 1-1/2 wraps of fabric must remain on the roller. This
screen comes standard with 0" or 2" black at top. See the specification data sheet for details.
CASE COVER
SCREW
FIGURE 4
▲
!
HOOK
FIGURE 5
ROTATE UP