Manual

ELECTRICAL INSTALLATION
Internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box
l
ocated on the left end of the screen case.
Standard installation is for a single 120VAC or 240VAC wall switch to control the screen. Optional Control units may have
been ordered. Wiring diagrams for the built-in VPI and low voltage control are included in these instructions. Refer to
a
dditional instructions for the external VPI, external low voltage control, SCB-100 and SCB-200. Refer to the appropriate
wiring diagram for your screen.
3
UP
OFF
DOWN
THIS SWITCH CAN NOT
BE USED WITH LVC.
120V WIRING DIAGRAM
FOR STANDARD
WALL SWITCH
SPDT SWITCH WITH
CENTER OFF
AC (COMMON)
AC HOT 120VAC 60HZ 1 AMP
BLACK/YELLOW
BLACK
RED
WHITE BLACK (DOWN) RED (UP)
J
UNCTION BOX
L
OCATED IN LEFT ENDCAP
W
HITE
B
LACK
RED
GREEN
M
OTOR
NOTE: A SINGLE SWITCH CANNOT BE USED TO OPERATE MORE THAN
ONE SCREEN. CONTACT THE FACTORY FOR FURTHER
INFORMATION.
G
ROUND–MUST BE CONNECTED
T
O BUILDING GROUND
G
ROUND TO CASE
240 VOLT WIRING DIAGRAM
FOR STANDARD WALL SWITCH:
Da-Lite offers two styles of 240 volt
wall switches for standard operation.
Please see wiring diagram included in
wall switch box included with screen.