INSTRUCTION BOOK FOR Tensioned Dual Masking Electrol
Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat. 4.
Pre-Installation 1. Carefully unpack screen and remove outer wrapping from case. 3. Remove center support brackets (on 8' and wider screens only), reverse brackets and reinstall flush with the top of the box 2. Make sure to recheck measurements of screen location before installation.
Screen Adjustment CAUTION! The mask should not be field adjusted for more or less drop. ATTENTION! Le masque ne doit pas être ajusté sur place pour régler la chute. CAUTION! Contact Da-Lite at 800-622-3737 or 574-267-8101 if screen motor needs adjustment. ATTENTION! Contactez Da-Lite au 800-622-3737 ou au 574-267-8101 au cas le moteur de l'écran a besoin d'être ajusté.
220V Dual Motor Control Up Down Common Ground Brown Up Black Brown Down Blue Black Common Green Blue Ground 4 – Wire Mask Motor Green 4 – Wire Screen Motor Mask Up Screen Up Off Mask Motor Down Screen Motor Down 220V. A.C.
Suggested Methods Of Installation METHOD A (Suggested) 1/4" Lag Screws METHOD B 9 3/16" 9" Mounting Bracket 1 1/2" 9 3/16" 9" (Suggested) 1/4" Lag Screws Mounting Bracket 1 1/2" 1 1/2" 1 1/2" Mounting Joist 8 11/16" Mounting Joist 8 15/16" Furring Strip Furring Strip 3/4" Finished 3 1/2" Ceiling Panel Can Be Painted Same As Ceiling or Removed And Replaced With Finished Ceiling Aluminum Slat Picture Surface Masking Surface 3/16" x 1" Steel Bar In Pocket Offset mounting, recessed above ceili
Troubleshooting Visit www.da-lite.com/products/tutorials.php to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email Symptom at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Cause Solution Incorrect line voltage. Verify 115-125V (or 220-240V). If insufficient voltage, rewire incoming electric line. Blown fuse. Replace fuse. Tripped circuit breaker.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory.
