Datasheet

TENSIONED DUAL MASKING ELECTROL
®
METHODS OF INSTALLATION
WHEN ORDERING, MARK APPROPRIATE SELECTIONS:
Select size from charts on first page.
Viewing surface:
o Da-Mat
®
o HD Progressive 1.1 Perf
o High Contrast Da-Mat
®
o Audio Vision
o Pearlescent o High Contrast Audio Vision
o Cinema Vision o Da-Tex
®
(Rear)
o High Contrast Cinema Vision o Dual Vision
o High Contrast Cinema Perf
GREENGUARD
®
and GREENGUARD
®
Children and Schools Certified.
Optional Accessories:
o Dual Motor Low Voltage Control System (DMC).
o Wireless Remote Control for DMC.
o Radio Frequency Remote.
o Radio Frequency Range Extender available
o Infrared Remote.
o 220 Volt (50Hz) Motor.
CASE LENGTH
SEE CHART
6-3/4"
Rev. 10/11
MOUNTING
BRACKET
MOTOR END
SWITCH CONTROL
OUTLET
FURRING
STRIP
1-1/2"
6-3/4"
9 "
8-3/4"
SELECT INSTALLATION METHOD
ACCORDING TO CEILING TYPE.
NOTE:
MUST MARK HOLE LOCATION OF
SCREWS IN 3½" PANEL FOR
REMOVAL, IF COVERING WITH TILE.
MOUNTING
BRACKET
8-15/16"
9"
9-3/16"
1-1/2"
1-1/2"
3-1/2"
PANEL
PICTURE SURFACE
MASKING SURFACE
3/4" FINISHED
CEILING
ALUMINUM SLAT
CAN BE PAINTED SAME AS CEILING
OR REMOVED AND REPLACED WITH
FINISHED CEILING
Offset mounting, recessed above ceiling. For plaster,
dry wall, tile or paneling. Bottom of case painted same
finish as ceiling.
(SUGGESTED)
¼" LAG
SCREWS
MOUNTING
JOIST
METHOD A
FURRING
STRIP
MOUNTING
BRACKET
9-3/16"
9"
9-3/16"
1-1/2"
1-1/2"
3-1/2"
P
ANEL
PICTURE SURFACE
MASKING SURFACE
3/4" FINISHED
CEILING
ALUMINUM SLAT
CEILING TILE CUT TO 1/4 " THICK
(ATTACH WITH MASTIC)
Offset mounting, recessed above ceiling. May be
adapted for ¾" ceiling, but cut to ¼" thick under screen
case and panel.
(SUGGESTED)
1/4" LAG
SCREWS
MOUNTING
JOIST
METHOD B
FURRING
STRIP
MOUNTING
BRACKET
9-3/16"
9"
9-3/16"
1-1/2"
1-1/2"
3-1/2"
PANEL
PICTURE SURFACE
MASKING SURFACE
FINISHED
CEILING
ALUMINUM SLAT
Offset mounting, recessed above ceiling. May be
adapted for ¼" paneling for ceiling.
(SUGGESTED)
¼" LAG
SCREWS
MOUNTING
JOIST
METHOD C
FURRING
STRIP
9-3/16"
(SUGGESTED)
¼" BOLTS
1-1/2"
1-1/2"
3-1/2"
P
ANEL
PICTURE SURFACE
MASKING SURFACE
SUSPENDED
CEILING TILE
ALUMINUM SLAT
T-BAR
FURNISHED
WITH CEILING
Flush mounting, recessed above ceiling. For use
with dropped ceiling. May also be adapted for use
with acoustical or other ceiling ¾" thick but cut to
¼" thick under screen case and panel.
MOUNTING
JOIST
METHOD D
AUDIENCE
SIDE
AUDIENCE
SIDE
AUDIENCE
SIDE
AUDIENCE
SIDE
NOTE: Drawings below
show picture surface
and masks in the down
position. Masks will be
on front side of roller
when retracted.
Project:
Architect:
Phone:
Contractor:
Phone:
Supervisor:
Phone:
Date:
Revised:
CENTER
BRAKCETS
3/16 " x 1" STEEL SLAT IN POCKET
3/16" x 1" STEEL SLAT IN POCKET
3/16" x 1" STEEL SLAT IN POCKET
3/16 " x 1" STEEL SLAT IN POCKET
o White box (black standard).
o Silent Motor (available on sizes up to 10' x 10').