INSTRUCTION BOOK FOR Tensioned Professional Electrol®
Important Safety Instructions Pre-Installation When using your video equipment, basic safety precautions should always be followed, including the following: 1. Carefully unpack screen. 2. Make sure to recheck measurements of screen location before installation. 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. Remove instruction cover plate (Fig. 1).
Installation Hangers (If required) 1. See Figure 3 for hanger placement. 2. Make sure hangers are placed to fit into notches of ironing board..
Installation 5. Install electrical hook up that applies to your unit. Make sure to review your Electrical Installation Checklists and wiring diagrams (included) for either 110 volt switch, 220/240 volt switch, or DRC low voltage control. 1. Level unit lengthwise with a carpenter’s plum level. AUTION! Do Not completely seal in unit. Access room C must be allowed for motor repair or fabric replacement. ATTENTION! Ne fixez pas complètement l'unité.
Tensioned Professional Electrol® Installation 9 1/2" 11 5/16" Reinforced Top Motor End Electrical Outlet Box Suggested Methods of Installation Rafters Ceiling Type Hanger 2" Moulding Picture Surface Picture Surface 1" x 3" Cleat Picture Surface Wall Type Hanger Ceiling Mount Without Hangers Screen case is placed flush with the wall and ceiling and held in position by moulding securely attached to the wall.
Tensioned Professional Electrol® Installation 120V Wiring Diagram In multiple control installations the switch is replaced by the low voltage control, operated from push button stations. Red (Up) Black (Down) White (Common) Green (Ground) White (Common) Red (Up) Black (Down) Black (Down) To junction box mounted in screen case, in which interal wiring terminates in white, black, and red leads. Up Green (Ground) AC Common AC Hot Off 115V. AC 60HZ 1 AMP. MAX.
Troubleshooting Visit www.da-lite.com to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom Cause Solution Blown fuse. Replace fuse. Tripped circuit breaker. Reset circuit breaker. Check above. Tighten all loose wire connections. Correct any improper connections.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.