INSTRUCTION BOOK FOR Boardroom Electrol®
Important Safety Instructions Installation When using your video equipment, basic safety precautions should always be followed, including the following: NOTE: Unit is not to be installed in air handling space. 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used.
Boardroom Electrol® Installation 6. Remove switch assembly (boxed, located at pin end of fabric). a limit switch is tripped and the motor shuts off. CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool. Remove by hand. CAUTION! Excessive continuous operation may cause overheating. ATTENTION! Ne coupez pas le ruban adhésif sur la toile avec un couteau ou un outil tranchant. Retirez à la main. ATTENTION! Le fonctionnement continu et excessif peut provoquer une surchauffe. 7.
Boardroom Electrol® Installation 120V Screens 120V Wiring Diagram Black White Red Red (Up) Up AC Common Off AC Hot 120V. AC 60 HZ 1 AMP. MAX. Down Side View of Switch & Box Normally Closed Door Limit Switch White (Common) Black (Down) Black (Down) To junction box mounted in screen case, in which internal wiriing teminates in white, black, and red leads. Red (Up) Motor In multiple control installations the switch is replaced by the low voltage control, operated from push button stations.
Boardroom Electrol® Intallation 220/240V Screens 240 Volt Wiring Diagram for Standard Wall Switch: Da-Lite offers two styles of 240 volt wall switches for standard operation. Please see wiring diagram included in wall switch box included with screen. Screen Adjustment For 220/240V Screens Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite.
Boardroom Electrol® Intallation Select installation method according to ceiling type.
Troubleshooting Visit www.da-lite.com/products/tutorials.php to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom Cause Solution Screen will not operate or will not go “down”. Motor does not hum. Blown fuse. Replace fuse. Tripped circuit breaker. Reset circuit.
Troubleshooting Symptom Cause Solution inge is bound or has a foreign substance on it H which does not allow it to open by gravity.. Check installation to free door. Clear any foreign substance; i.e., paint or plaster from hinge. Slat hooks catch on access door.. Adjust slat hooks. Door can be opened by removing four screws holding slat hooks to door. Access should be provided to these screws during and after installation. Door will not open Door does not close tightly.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
