INSTRUCTION BOOK FOR Tensioned Cosmopolitan Electrol For Sizes Up To 10' x 10'
Important Safety Instructions Pre-Installation When using your video equipment, basic safety precautions should always be followed, including the following: 1. 1. 2. Remove shipping brackets by removing the screws from the slat bar and wooden board and use supplied 1/8" next key to remove silver shipping brackets attached to slat. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3.
Tensioned Cosmopolitan® Electrol® Installation Motor End 4 5/8" 13/32" Overall Length of Case 1 7/8" 3/4" Diameter Hole For Wall Installation Between Hanger Eyes 3/8" Diameter For Ceiling Mounting 5 7/8" Enclosure Cover 7/8" Diameter Opening For Electrical Settings Picture Surface Slat Overall Length of Slat Wiring Enclosure Cover 120V Wiring Diagram Up Off Down Side View Of Switch And Box Down White Limit Switch Adjustment Up Red Common White Black Rocker Switch Down Black To Junction Box,
120V Wiring Diagram with Optional Built-In Low Voltage Control 3-conductor 20-24 gauge wire can be used in place of the supplied RJ-14 cable to connect the wall switch. Connect the BUS terminals on the wall switch to the corresponding BUS terminals on the splitter board. IMPORTANT NOTE: The wall switch is REQUIRED to make any limit switch adjustments, EVEN if a third party control system is used. Therefore, it is advised to wire the switch or provide a 3-conductor connection that is accessible.
120V Wiring Diagram with Optional Built-In Video Projector Interface CAUTION: The projector must be turned off before connecting the trigger wires to the projector. Failure to do so may damage the controller. ATTENTION: Le projecteur doit être éteint avant de brancher les fils de déclenchement à celui-ci. Tout manquement à cette instruction pourrait endommager le contrôleur.
Tensioned Cosmopolitan® Electrol® Installation Connect Supplied RJ9 Cable to Splitter and Switch, or use 4 Cable Conductor to Connect to Screw Terminals.
Troubleshooting Visit www.da-lite.com to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at Symptom Screen will not operate. Motor does not hum. info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Cause Solution Incorrect line voltage. Verify 115-125V (or 220-240V). If insufficient voltage, rewire incoming electric line. Blown fuse. Replace fuse.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory.
