User manual

61
• 1:10
• Thres. - Compressor threshold.
Below there is a simple parametric equalizer, the EQ section:
• Hi – Hi-shelf gain from -24db to +24db for frequencies >= 8khz.
• Mid frq. – Center frequency of the peak for middle frequencies from 100hz to 10khz.
• Mid – Gain value for a peak for middle frequencies from -24db to +24db.
• Low – Low-shelf gain from -24db to +24db for frequencies <=100hz.
The Pre.Comp. switch controls the sequence of processing by the Compressor and EQ sections. If Pre.Comp. is:
• On – the signal is rst processed by the compressor and then its output is processed by the EQ.
• Off – the signal is rst processed by the EQ and then its output is processed by the Compressor.
In Send section we have three parameters which control the amount of signal. After processing by a channel strip (but
before the fader) the signal is sent to FX channels.
Mixer • Layer channel strip
3
Mixer - layer's channel strip - eq
Mixer - layer's channel strip - send section