User manual
55
2
• Sustain pedal mode - Sustain pedal apart from its basic task of sustaining the played notes, can be also used as a
Source in the Modulation Matrix. Therefore we might want to disable sustaining the notes by the pedal, to limit
its usage to the Modulation Matrix only. It is possible to perform this action using this option. There are two
variants we can select from:
• Note not sustained - Sustain pedal does not sustaining notes and works in the Modulation Matrix only.
• Note sustained - (default value) Sustain pedal fulls its basic function and sustaining notes when we press it and
at the same time it can be used as a Source for the Modulation Matrix.
• Polyphony mode - Polyphony for the Layer is limited by a set of voices / generators, that are allocated to the
individual MIDI notes played on the keyboard. If polyphony is too small then during the playback of complex
keyboard phrases, sounds, which were triggered earlier by MIDI notes and are still playing, need to be stopped by
successively and continuously incoming new MIDI notes (because of the limited polyphony). This concerns mainly
sounds with longer release times. In LuSH-101 we can choose how notes should be distributed among available
voices of polyphony (the order in which voices should be assigned to incoming notes and later released). There are
two modes built-in:
• First played rst released - (default value) This way is analogous to a queue, in which a rst assigned voice
to a note (considering the timeline) will be also the rst one released - Method inspired by Korg's analogue
synthesizers.
• First played last released - Voices management is done in a way similar to a stack, where the last assigned voice
to a note (considering the timeline) will be also the rst one released - This method was inspired by Roland's
analogue synthesizers.
• Oscillators Hard Restart - The option is turned off by default. In case of its activation the oscillators phase (VCO)
of a given layer is reset each time a new note is being played. The Legato (overlapping notes) for the monophonic
mode is an exception, in which the incoming of a new note does not erase the oscillator phase, even with the
Oscillators Hard Restart option activated.
All settings from the Timbre Preset Settings panel are stored along with the Timbre / Layer preset.
Layer • Timbre Preset Settings