User manual
50
Layer • Modulation Matrix
2
- Moving up a selected row,
- Moving down a selected row
A row can be selected by a mouse-click on any of its controls, (selected row becomes highlighted).
Voice Volume - A special destination parameter
In the Destination column we have a specic parameter available which can be selected, namely Voice Volume (in
a Source Mixer node). This parameter has no equivalent in any of the GUI parameters. It controls the volume of a
single voice generated by the synthesizer. Using it as the Destination in the Modulation Matrix enables achieving
typical volume dynamics. This parameter works according to a slightly different formula than other Destinations in
the Modulation Matrix. When the Amount value is set to 0, the Voice Volume is not modied at all (lack of volume
dynamics). In case of setting the Amount to 1, the MIDI note Veloticy affects the Voice Volume to full extend
(maximum Volume dynamics) in accordance witha principle: The greater the Velocity of a MIDI note, the louder the
sound is generated. But if we set the Amount to -1, then the note Velocity is inversely proportional to the sound
volume (Voice Volume); the greater the velocity value of a MIDI note, the quieter the sound is generated.
Arpe Gate, Arpe Tie - special modulation sources
In regard to Sources in the Modulation Matrix, most of them are just external MIDI events that come in from an
active port redirected to the LuSH-101. The Arpe Gate and the Arpe Tie are two exceptions of that rule, because
they are both generated internally by the Layer Arpeggiator. Moreover, these are not continuous parameters, but
binary sequences generated by the Arpeggiator based on the states of Gate and Ties steps. If the step is set, then the
generated value is 1, otherwise 0.
Tie and gate step values