User manual
31
• Wheel – Allows controlling, through the modulation wheel, the depth of effect of LFO1 on the oscillator
frequency or/and lter cutoff frequency. We have the following parameters:
• VCO – The depth of modulation of the oscillator's frequency by LFO1's output – gives a vibratto effect
controlled by the modulation wheel.
• VCF – The depth of modulation of the lter frequency by LFO1's output.
Note: Please note that the waveform of the LFO1 output for the wheel section is always triangular. The waveform parameter
in LFO1 section is ignored here.
• Bender – Allows using the pitch bender to control oscillator's frequency or/and lter cutoff frequency. There are
two parameters:
• VCO – The range the bender affects the oscillator's frequency.
• VCF – The range the bender affects the lter cutoff frequency.
The diagram below presents the manner in which VCO parameters in Bender and Wheel sections inuence the
oscillator frequency:
Layer • Synthesis
2
Wheel and bender affecting vco