User manual

11
Layer • Layer settings
2
• Voices – It is the total number of voices of Polyphony for Layer (up to 32 voices). If the number of voices is
equal to 1 then implicitly the Mono mode is set and other controls in this section start to work.
• Mono – This button turns on/off the Mono mode. If the number of voices of Polyphony is greater than 1, then
we may use this switch to overturn the Mono mode on. In this situation the Polyphony is automatically reduced
to one voice.
• Mode – This controls the Portamento mode and works only in the Mono mode and it has three values:
– Off – Portamento is off.
– On – Portamento is always on (for overlapping and non-overlapping MIDI notes).
– Auto – Portamento works only for overlapping MIDI notes.
• Time – It is the time of smooth pitch transition between two successively incoming notes.
Unison:
Unison mode allows to play a single note with a few voices of Polyphony at the time, in which each voice is slightly
changed (its Tune, Panorama or/and lter's Cutoff). By default, Unison mode is turned off (value of Voices shows 1).
Increasing Voices LED display in Unison section turns on Unison, and Spread knobs become active.
• Tune – The strength of detune voices in Unison.
• Pan – The spread of Panorama of voices in Unison.
• Cutoff – The strength of lter Cutoff spread among the voices of Unison.
Voices - unison settings