Installation Guide

Installation Instructions for your
Mission Iron Pedestal Stand
_____________________________________________________
Items needed for Installation:
• 100 % clear silicon bathroom adhesive for installation of slab.
• Electric drill with 5/32" masonry drill bit if attaching to concrete or tile floor.
• (2) 3/16” x 1 ¼” masonry screws if attaching to a concrete or tile floor.
• (2) #10 x 2” construction screws if attaching to a wood floor.
• (2) # 10 x 2 ½” construction screws for attaching to wall structure.
• Level
• Philips tip screwdriver and ratchet with 5/16" socket for masonry screw installation.
________________________________________________________________
Directions:
•
Carefully unpack components.
• Check fit of pedestal against wall surface, minor adjustments may need to be made
to the pedestal that will ensure a proper fit to wall and floor.
• D'Vontz strongly advises attaching to solid wood wall structure i.e. (stud or 2x4
nailer). See fig. 1-A. If mounting to masonry wall use appropriate masonry screws.
Fig. 1-A Fig. 1-B
•
Level pedestal across the top ring and mount to wall structure using the #10 x 2 1/2 "
construction screws.
•
If floor is concrete or tile drill two 5/32” holes into floor through the base of the
pedestal. Install two masonry screws to anchor pedestal to the floor.
•
If floor is wood, screw two #10 construction screws through base of pedestal.
• Position slab so that it is centered on pedestal, flush against the wall before applying