Installation Guide

Fig. 1-B Fig. 1-C Fig. 1-D
• Check for any excess sealant that may have been squeezed to the inside
of bowl. Remove with soft cotton rag. Allow an hour of set time for
sealant before installing on cabinet.
• Cabinet instructions should be followed at this point prior to setting
assembled slab and sink.
• After installing cabinet, silicone adhesive should be applied between
cabinet corners and slab to attach countertop to cabinet.
• Carefully support sink and slab, set onto cabinet frame and align with
cabinet.
• Please note drain tailpiece must be designed for use with Lautus
Undercounter marble sinks.
• Install tailpiece drain - remove the mounting nut and rubber beveled
washer from tailpiece drain. If tailpiece came with a thin rubber washer for
mounting under flange, please discard.
• Apply a bead of silicone sealer under the mounting flange of the tailpiece
and position into the drain hole of the Vessel. Do not use plumbers
putty under the flange for this may damage or discolor stone. Work
into place by slowly pressing the tailpiece until it seats against sink. You
should have a small amount of sealer squeezing out between the tailpiece
flange and sink.
• While holding the tailpiece in place, slide the beveled rubber washer onto
the tailpiece beveled side up. Follow with metal washer (if provided) and
mounting nut.
•
Tighten mounting nut. Nut torque just needs to be enough to seat
tailpiece flange firmly into Vessel. Do not over tighten. Remove any
excess sealer inside the Vessel with a soft cotton rag.
• Connect overflow tube to drain tailpiece. Tube may need to be trimmed
at this point for proper fit.