Installation & Assembly_1

Installation Instructions for your D’Vontz Square or

Round Bar and Prep Copper Sink

Items needed for Installation:

• A quality 100% clear silicon sealer.

• Sink drain for appropriate drain diameter. (D’Vontz or Westbrass)

• Soft cotton rag.

• Pencil

• Tape Measure

Directions:

Drop In Installation:

• Determine location on countertop for sink. Turn sink upside down and place on

countertop. Lightly trace the outside edge of your sink with a pencil. Remove

sink and scribe line with pencil 1” inside outside line. See Fig. A. Cut countertop

to this dimension. Since these sinks are manufactured by hand, we are unable to

provide a template due to variations that occur in size.

Fig. A

• Once countertop hole is cut, set sink inside hole and center. Ensure sink flange

sits flat on top countertop.

Countertop Cut

Line

Sink Trace Line

PAGE 1
Installation Instructions for your D’Vontz Square or Round Bar and Prep Copper Sink Items needed for Installation: • • • • • A quality 100% clear silicon sealer. Sink drain for appropriate drain diameter. (D’Vontz or Westbrass) Soft cotton rag. Pencil Tape Measure Directions: Drop In Installation: • Determine location on countertop for sink. Turn sink upside down and place on countertop. Lightly trace the outside edge of your sink with a pencil.
PAGE 2
• Before setting sink in countertop, prepare and attach drain to sink. Use silicone sealer under drain flange. After tightening tailpiece remove excess sealer. • Run a ¼” bead of silicon sealant inside of pencil line. Carefully set sink into countertop hole and sealant. Once positioned, carefully remove excess sealant from the outside rim of sink with a soft cotton rag while holding downward pressure on sink.