Operation Manual

Drive Partner for your Safety
36
BX1000 / BX1000 Plus User Guide
www.d-teg.com
37
OPTIONAL ACCESSORY (Permanent Power Cable)
Model name: DPWR-100
The permanent power supply cable will allow you to hard wire the BX1000 series to the
fuse box of your vehicle.
The ground cable should be
contacted at the car body.
Connect (+) to the reserve Fuse.
APPENDIX (Upgrade)
1. Prepare Firmware
Make a [program] folder on the SD root folder as shown below,
NOTE Togettheupgradermware,pleasecontactyourlocaldistributor.
WARNING Do not turn off the power during upgrade.
If the upgrade fails, the BX1000 / BX1000 Plus unit should be returned to your
local distributor.
Copy“BX1000_X.X.X.bin”leintotheSDcard[program]folder.
2. Upgrade BX1000 / BX1000 Plus
Insert the prepared SD card to BX1000 / BX1000 Plus unit and turn on the
power.
TheBlue&RedLEDwillblinkquicklywhiletheunitisupgrading.Itwillalso
‘beep’ continuously. Upgrading the unit usually takes about 2 to 3 minutes.
Once
theupgradeisnished,theunitwillautomaticallyturnoff/onthepower.
If BX1000 series records as normal, turn off the power.
Insert the SD card into your PC and initialize it using the software.
❶
Recorder
❷
Fuse box(+)
❸
Ground
1)UpgradetheBX1000/BX1000Plusmainunitrst.
2) Install new PC viewer software on your PC.
3) Initialize the SD card using new PC viewer software.